Intec XP2020 Transfer Belt Reset Chip

  • Name: Intec XP2020 Transfer Belt Reset Chip
  • Product technology: Transfer Belt Reset Chip
  • Installation method: Super Easy Peel and stick
  • Compatible with: Intec XP2020 INT21152412
£15.00 excl tax

Intec XP2020 Transfer Belt Reset Chip

Zinetic supply transfer belt reset chips that will work with the Intec XP2020 printer series. If your printer has told you to replace the transfer belt, a new chip will reset the belt page page count, allowing you to carry on using your transfer belt for another cycle. This will allow you to save more money by using your transfer belt for another cycle. So if you have a message saying ‘Replace Transfer Belt, Belt Unit Near Life, Change Belt Unit’ warning that appears on your printer, but the belt is still working, you can save lots of money by installing a transfer belt reset chip. All our reset chips for the Intec printers are installed with a super-easy ‘peel and stick’ method, with specific model instructions so the reset chip can be replaced in seconds. This will allow your belt to function for another cycle, saving you time, money and massive amounts of environmental waste.

How To Install A transfer Belt Reset Chip

Other Useful Information:

The chip is super easy to install. Its installed on the outside of the transfer belt so you do not need to take the belt apart to install the chip. It is super easy! You do not need any tools to install the chip – just stick the chip to the belt in the correct location

The chip works with transfer belts that are supplied free with the printer (starter belt) and also replacement transfer belts that you buy when required.

Detailed instructions showing you where to attach he chip will be provided by email (pdf) and you can also watch the video instructions located on this web page.

FURTHER INFORMATION:

Our chip is single use and will reset one transfer belt.

Each chip has double sided tape attached to it which will allow it to attach securely to your transfer belt. How it works - attach the chip onto your transfer belt in the correct location – do this when the printer is turned off, then turn the printer power back on. You will need to wait while printer to calibrates and then your transfer belt will be reset to 99% life remaining.

The transfer belt that you want to reset must have be in proper working condition before the warning message replace transfer belt was displayed. You cannot reset a faulty belt.

The transfer belt reset chip does not reset the imaging drums, fuser unit or any toner cartridge levels!

If you have problems with print quality or error codes other than the "Replace Transfer Belt, Belt Unit Near Life, Change Belt Unit" message please contact us before you purchase this item.

This Intec XP2020 Transfer Belt Reset Chip is guaranteed to work in the following printers

Customers who bought this item also bought

Intec XP2020 Compatible Drum Unit

  • Name: Intec XP2020 Compatible Drum Unit
  • Manufacturer: Zinetic
  • Product technology: Laser
  • Product type: Drum Unit
  • How many pages: Page yield: 30000 pages
  • Compatible with: Intec XP2020
  • Page yield: 30000 pages, INT01233208, INT01233207, INT01233206, INT01233205
    £70.00 excl tax

    Intec XP2020 Toner Refill Rainbow Value Pack

    Intec XP2020 Toner Refill Rainbow Value Pack

    Refill your empty Intec XP2020 toner cartridges INT43837137, INT43837138, INT43837139, INT43837140 and save up to 80% !!

    You can refill your empty Intec XP2020 toner cartridges using the Unplug, Empty and Refill method. It will take approx. 5 minutes to refill a cartridge and this can be done without the need for any special tools or equipment.

    Each kit contains:

    £230.00 excl tax